Magma x JamgHe Pure Crystal Transparent Photopolymer Resin 500g

Magma Pure Crystal Transparent Photopolymer Resin Series 500g

Specially formulated non-yellowing pure crystal transparent photopolymer resin. It does not consist any volatile organic chemicals (VOC's) and EN 71-3 certified. Suitable for most LCD/ DLP/ MSLA 3D Printer with 355-405nm wavelength. 

How to make it Glass-Like/ See- Through?

After the post processing stage, apply clear coat to the pure cyrstal transparent printed object and it will looks glass-like/ see through!

Suggested Exposure Time (Based on 405nm UV)

(RGB )50 Micron: 6 to 10 sec / Base 50 to 80 Sec
(Mono) 50 Micron: 2 to 4 sec / Base 40 to 50 Sec

NOTE: The exposure time should be adjusted according to printer light energy, layer height and model structure.

Benefits:

- Non- yellowing

- Scratch Resistance

- Complied with EN 71-3 safety standard.

Technical Data Specifications

Cleaning & Post Curing

Step 1 - Prepare two containers with IPA (> 95%), and place the object into the first container and gently shake it or gently brush it with a soft brush. After that soak it in the second container for about 1 minute

Step 2 -  Dry the object with cold air. Ensure it is fully dry.

Step 3-  Place the object in the UV Curing Chamber to cure. The curing time is proportional to the volume of the work piece and inversely proportional to the optical power of the curing chamber.

Storage 

• Shake well before use, and leave it for 30 minutes to eliminate air bubbles generated from the shaking process.
• Packed in opague UV safe bottle for ease of handling and safe storing.
• Recommended storage temperature at 2-27°C (59-80°F) 
• After use, it should be filtered and keep back in the opague UV bottle on time and placed in a dry and well ventilated place.
• Store in cool and dry place, and avoid sunlight, recommended temperature at 25-30 degrees Celsius.

Important Safety Notices

• Please wear mask and non-powdered nitrile gloves while handling with resin as the product is in a liquid state with slight odor.
• Do not heat this product as photopolymer resins may produce vapours that may cause discomfort when exposed to high temperatures.
• Keep the product out of children’s reach.
• Avoid skin or eye contact with the uncured resin. If accidental contact occurs, please immediately rinse the affected area thoroughly using clean water.
• Uncured resin in the tank may be harden if exposed to sunlight before disposal. Be aware when discarding uncured resin and do not dispose the uncured resin directly into the sink. 
• After printing, please clean the uncured resin on the surface of the printed object using isoprophyl alcohol.
• Dispose of waste in accordance with local environmental regulations.

Sold by 3D Gadgets Malaysia