Magnetic Double Sided Textured Spring Steel Sheet for 3D Printer Creality Ender3 Ender 3 CR10 Ender5 TwoTrees
- Better adhesion
- Easy to print especially for new user
- Easy to remove by bending and popping the printed object off
- Easy to maintain
- Double-sided textured for your preference
- Hardened steel spring sheet - wont deform
- Never warp & Never rust.
NOTE: There might be some minor aesthetic issues caused from the manufacturing process for this material but it will not affect the performance of this product or the print quality.
The best upgrade for your 3D Printer. With this Magnetic Double Sided Textured + Smooth PEI Spring Steel Sheet, it is much easier print with great adhesion and removing prints by just slight bending.
Easy to print especially for new user
Easy to remove by bending and popping the printed object off
Easy to maintain
Pre installed 3M tape
Double-sided textured for your preference
Hardened steel spring sheet - wont deform
Never warp & Never rust.
235x235mm - recommended for 3D Printer Two Trees Bluer, Two Trees Sapphire Pro, Creality Ender 3 Series, BIQU B1 and Artillery Genius
310x310mm - recommended for Creality CR10S Series, Two Trees Bluer Plus, Two Trees Sapphire Plus, Artillery Sidewinder X1
- When installing the base magnetic with pre-applied 3M sticker, ensure the surface is clean and begin to stick it in one direction from the top and slowly push towards the bottom to ensure it is flat and no bubbles.
Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface
Note: Do not use ACETONE to clean the PEI surface.
1 x Magnetic Double Sided Textured Spring Steel Sheet
Sold by 3D Gadgets Malaysia