eSUN Elastic eResin-eLastic Photopolymer Resin 0.5KG

eSUN Elastic eResin-eLastic Photopolymer Resin 0.5KG

High elongation at break, good elasticity, tear resistance, tensile, bending and compression, quick rebound, a certain wear resistance.

Compared with eResin-Flex, the viscosity is greatly reduced to ensure release and molding. The release rate is relatively high and easy to print, lower hardness and the molded parts are softer and more elastic; meanwhile the bending performance is improved to make the thick parts can withstand more times and large Angle bending. It can be used on product models that require softness.

Advantages:

- Good elasticity

- Tear resistance

- Bending resistant

- High toughness

- Low hardness

- Low viscosity

Applications:

Mechanical, Automobile, Electronic appliances, Conveying pipeline, Sporting goods

Specifications

3D PRINTING PHOTOPOLYMER RESIN: eResin-Elastic

Viscosity(mPa·s) 500-900

Density(g/cm3) 1.080-1.085

Tensile Strength(MPa) 4-5

Elongation at Break(%) 250-350

Flexural Strength(MPa) /

Impact Strength(J/m) /

Tearing Strength(GPa) 8-10

Heat Distortion Temp(℃) /

Hardness(Shore A) 70A

NOTES:

1.Shake well before printing

2. Slice setting:

Stronger support: Avoid break with main body

Denser support：Avoid deformation dislocation

3.Printing data

Higher lifting distance: full film realse

Lifting distance：≥6mm

Slowing down Lifting speed: avoid breaking

Lifting speed: ≤60mm/min

Control leveling time: full leveling

Light off delay≥6s

4.Post Curing

Properly control the post curing time, the longer the exposure time, the higher the hardness of the curing material, the worse the flexibility, and the heavier the yellowing

To ensure good flexibility of the material and avoid hardening problems caused by post-curing, it is recommended to clean the printed parts after printing instead of post-curing

The surface sticky hand condition will be gradually improved under the indoor weak light condition. Avoid strong light exposure for later storage

Sold by 3D Gadgets Malaysia