RAMPS 1.4 Printer Controller

RAMPS 1.4 Printer Controller compatible with mega2560

Description:

RepRap  Mega Pololu Shield, or RAMPS for short. It is designed to fit the entire electronics needed for a RepRap in one small package. RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion. Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.

Version 1.4 uses surface mount capacitors and resistors to further cover edge issue cases.

Features and Benefits:
     1 It has Cartesian robot and the requirements of the extruder.
     2 extended to control other accessories.
     3 heater / fan output and three thermistor circuit MOSFET.
     4 fusion 5A additional safety and component protection
     5 heating control extra bed 11A fuse
     6 Suitable for 5 Pololu stepper driver board
     7.Pololu board pin socket, so they can be easily replaced or removed for future designs.
     8.I2C and SPI pins left for future expansion.
     9 All the MOSFET PWM pin is hooked into versatility.
     10. Servo connector for connection to the end stop block, the motor and the light emitting diodes. These connectors are gold-plated, rated current of 3A, very compact.
     11.SD card add - is now available from the Kliment-Sdramps
     12.LED indicate when the heater output
     13 Option 2 motors connected to the Z Prusa Mendel

Package includes:

1 x RAMPS 1.4 Printer Controller

Sold By 3D Gadgets Malaysia