BIGTREETECH Manta E3EZ Mainboard Upgrade to Klipper for FDM 3D Printer

The BIGTREETECH MANTA E3EZ V1.0 is a motherboard that can help you upgrade your Ender 3 printer to run Klipper or even Marlin with all of the latest features. It’s the first motherboard that incorporates “Manta” technology (B2B connectors for the CB1 or CM4 modules) and “EZ” technology (the ability to use the latest EZ drivers). By simply plugging in the CB1 core board and EZ drivers on the motherboard, you can upgrade your Ender 3 printer without needing an external raspberry pi. This saves you messy cabling and results in a highly compact implementation.



Note:
- The CB1 couldn't be connected to the PI TFT screen. The DSI/CSI port will only work while using CM4.
- The PI4B should be used with CB1 or CM4 core board to run Klipper.
- BIGTREETECH MANTA E3EZ V1.0 motherboard is not 100% compatible with other Ender machines due to the amount of features crammed into it. As a result, minor printable adapters are required.
Link: https://github.com/bigtreetech/Manta-E3EZ


Display Compatibility:
MANTA series motherboards support SPI and HDMI screen.


✅ Installed with 32-bit 64MHz ARM® Cortex-M0+ chip, more stable and faster. Able to run Marlin without CB1/ CM4.
✅ Designed with the same connector with Raspberry Pi, for fit connection with CB1.
✅ TPS5450-5A Power Chip The 5A output perfectly matches the power supply need of Raspberry Pi.
✅ EZ driver slots, easy and safer.
✅SPI & HDMI spot available to support colour touchscreen.
** Direct screwhole to fit on Ender 3, MANTA E3EZ V1.0 motherboard is not 100% compatible with other Ender machines due to the amount of features crammed into it. As a result, minor printable adapters are required.

Package Includes:
1 x BIGTREETECH Manta E3EZ Mainboard
1 x 1 set of wire connector with pin

Sold By 3D Gadgets Malaysia