MKS-Gen V1.4 Printer Controller with Stepper driver

prt0003

New product

An affordable 3D printer controller with the flexibility of swapping stepper driver and powered by ATmega2560.

More details

In Stock, Ship on next business day.

RM179.00

Add to wishlist

Data sheet

Warranty 3 months

More info

Features:

  1. Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware
  2. Firmware can use the same configuration as ramps1.4
  3. Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
  4. Easy connect MKS TFT on AUX-1
  5. All extra pins broken out the same as ramps1.4(AUX-1,AUX-2,AUX-3,Servos1)
  6. 3x temperature ADC connectors for thermistors
  7. up to 5 motor driver with easy micro stepping setup (micro switches)
  8. 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)
  9. 4 layers PCB, optimize heat dissipation.
  10. 3* 5V output, 3* 12V-24V output interface.
  11. 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
  12. Recoverable fuse for short-circuit protection.

Package Contains:

1x MKS-Gen V1.4 Printer Controller
1x USB Cable
5x A4988(1A) Stepper Driver

Resources:

Additional Info

Downloads and Info

Reviews

Write a review

MKS-Gen V1.4 Printer Controller with Stepper driver

MKS-Gen V1.4 Printer Controller with Stepper driver

An affordable 3D printer controller with the flexibility of swapping stepper driver and powered by ATmega2560.